5 Internal module
Alarm indicator
6 Rear module Alarm
indicator
Table 4-29 describes the indicators on the front panel of a high-density disk enclosure.
Table 4-29 Description of the indicators on the front panel of a high-density disk enclosure
Module
No. Indicator Status and Description
System
subrack
1 Location
indicator
l Blinking blue: The high-density disk
enclosure has been located.
l Off: The high-density disk enclosure is not
located.
2 Alarm indicator
l Steady red: An alarm is generated in the high-
density disk enclosure.
l Off: The high-density disk enclosure is
running correctly.
3 Power indicator
l Steady green: The high-density disk
enclosure is powered on.
l Off: The high-density disk enclosure is not
powered on.
4 Overtemperature
Alarm indicator
l Steady red: The temperature of the high-
density disk enclosure is too high.
l Off: The temperature of the high-density disk
enclosure is within the normal range.
5 Internal module
Alarm indicator
l Steady red: Internal disk modules of the high-
density disk enclosure are faulty.
l Off: Internal disk modules are running
correctly.
6 Rear module
Alarm indicator
l Steady red: The number of rear field
replaceable units (FRUs) is fewer than half of
that in standard configuration or rear FRUs
are faulty.
NOTE
Modules on the rear of the high-density disk enclosure
include power modules, fan modules, and expansion
modules.
l Off: Rear FRUs are running correctly.
Indicators on the Rear Panel
Figure 4-69 shows the indicators on the rear panel of a high-density disk enclosure.
OceanStor 2600 V3
Product Description
4 Hardware Architecture
Issue 09 (2019-05-15) Copyright © Huawei Technologies Co., Ltd. 85
To Next Page
Loading...
