4. Put the removed interface module into an ESD bag.
Step 4 Remove the cables from the controller.
Step 5 Press the latch on the controller to release the handles and pull out the controller, as shown in
Figure 5-35.
Figure 5-35 Removing a controller
Step 6 Place the removed controller into an ESD bag.
Step 7 Take the spare part out of its ESD bag.
Step 8 Open handles on the spare part, insert it, and close the handles, as shown in Figure 5-36.
OceanStor Dorado V3 Series
Parts Replacement
5 Replacing FRUs
Issue 05 (2019-01-30) Copyright © Huawei Technologies Co., Ltd. 108
To Next Page
Loading...
