Huawei OceanStor Dorado V3 Series

To Next Page

To Previous Page

Figure 4-62 Removing a fan module

Step 4 Put the removed fan module into an ESD bag.

Step 5 Take the spare part out of its ESD bag.

Step 6 Open the handle of the spare part, insert the spare part into the empty slot, and close the

handle, as shown in Figure 4-63.

Figure 4-63 Installing a fan module

Step 7 Wait about one minute and check the status of the Running/Alarm indicator on the fan module

to determine whether the fan module is successfully installed. Figure 4-64 shows the location

of the Running/Alarm indicator on the fan module.

OceanStor Dorado V3 Series

Parts Replacement

4 Replacing CRUs

Huawei OceanStor Dorado V3 Series - Page 67