Figure 5-11 Replace Optical Module Wizard 4-2
NOTE
If services on the port corresponding to the replaced optical module fail, the Danger dialog box is
displayed.
l If the risk can be ignored, select I have read and understand the consequence associated with
performing this operation, click OK, and go to Step 7.
l If you need to perform the replacement again, click Cancel and then confirm that the interface
module and the controller corresponding to the optical module are working normally. If the Danger
dialog box is displayed again, contact Huawei technical support.
Step 7 Click Next.
The optical module replacement page is displayed.
NOTE
You can proceed to the next operation only when all items pass the pre-replacement check.
Step 8 Replace the optical module by performing operations in the operation guide.
OceanStor Dorado V3 Series
Parts Replacement
5 Replacing FRUs
Issue 05 (2019-01-30) Copyright © Huawei Technologies Co., Ltd. 79
To Next Page
Loading...
