This table may not list some tools, materials, or consumables required at specific sites. Onsite
installation personnel and technical support personnel should prepare tools based on site
requirements. Firestop putty is used to seal the cable inlet and outlet holes after cable connection,
and needs to be prepared by the customer.
3
Acceptance Guide
1. After the equipment is delivered to the installation site, representatives from the customer and
Huawei unpack and inspect the equipment together.
2. If any damage is found, report it to the carrier immediately.
1. (Optional) Check whether the tiltwatch indicator on the carton has turned red. If yes, record the
information and contact the equipment carrier and the local Huawei office immediately.
2. Visually inspect the equipment appearance to check whether the equipment is paint-peeling,
deformed, scratched, or soaked. If yes, record the information and contact the equipment carrier
and the local Huawei office immediately.
3. Check the equipment and fittings against the packing list, and ensure that the equipment and
fittings are correct and complete. If any fitting is missing or does not comply with the model in
the packing list, record the information and contact the local Huawei office immediately.
Unpacking and Acceptance
3.1
To avoid damaging the equipment, exercise caution when removing the packing materials.
3.2
Removing the Package
1. Move the PDC to the specified installation position using a pallet truck.
2. Cut off and remove the binding straps, as shown in the figure.
3. Remove the packing materials and foam.
4. Remove the plastic bag, take out the fitting box, and put it aside.
3
To Next Page
Loading...
