Operation Manual - STP
Quidway S3000 Series Ethernet Switches Chapter 1 RSTP Configuration
2-27
Table2-25 Enable/Disable MSTP on a port
Operation Command
Enable MSTP on a port. stp enable
Disable MSTP on a port. stp disable
Restore the default MSTP state on the port. undo stp
You can enable/disable MSTP on a port with either of the above-mentioned measures.
For more about the commands, refer to the Command Manual.
Note that redundant route may be generated after MSTP is disabled.
By default, MSTP is enabled on all the ports after it is enabled on the device.
2.3 Display and Debug MSTP
After the above configuration, execute display command in any view to display the
running of the MSTP configuration, and to verify the effect of the configuration. Execute
reset command in user view to clear the statistics of MSTP module. Execute
debugging command in user view to debug the MSTP module
Table2-26 Display and Debug MSTP
Operation Command
Show the configuration information
about the current port and the switch.
display stp [ instance instance-id ] [ interface
interface-list | slot slot-num ] [ brief ]
Show the configuration information
about the region.
display stp region-configuration
Clear the MSTP statistics information. reset stp [ interface interface-list ]
Enable/Disable MSTP (packet
receiving/transmitting, event, error)
debugging on the port.
[ undo ] debugging stp [ interface interface-list ] { packet
| event }
Enable/Disable the global MSTP
debugging.
[ undo ] debugging stp { global-event | global-error |
all }
Enable/Disable specified STI debugging [ undo ] debugging stp instance instance-id
To Previous Page
Loading...
Need help?
General