Figure 4-2 Traffic distribution based on ECMP
S9300A
Server 1 Server 2 Server 3
Server 4
GE 1/0/1
GE 1/0/2 GE 1/0/3
GE 1/0/4
S9300CS9300B
Upstream
Traffic Splitter
XGE 2/0/1
Pre-configuration Tasks
Before configuring traffic distribution based on ECMP, complete the following tasks:
l Powering on the device normally
l Setting IP addresses of interfaces
Data Preparation
To configure traffic distribution based on ECMP, you need the following data.
No.
Data
1 IP addresses of interfaces
2 Static routes
4.4.2 Configuring Static Routes
Context
Through multiple static equal-cost routes, packets are forwarded to analysis devices according
to the specified load balancing mode.
Do as follows on the Switch where equal-cost routes need to be configured.
Quidway S7700 Smart Routing Switch
Configuration Guide - QoS 4 Traffic Distribution Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
101
To Next Page
Loading...
