Huawei quidway s7700 - Configuring a Traffic Policy; Applying the Traffic Policy

NOTE
You can disable MAC address learning as required:
l To disable MAC address learning on an interface, in a port group, or in a VLAN, run the mac-address
learning disable command in the corresponding view.
l To disable MAC address learning for the packets matching a specified traffic classifier, run the mac-
address learning disable command in the traffic behavior view.
----End
1.4.4 Configuring a Traffic Policy
You can associate a traffic classifier with a traffic behavior in a traffic policy.
Context
When creating a traffic policy on the S7700, you can specify the matching order of traffic
classifiers in the traffic policy. The matching order includes the automatic order and
configuration order:
l If the automatic order is used, traffic classifiers are matched based on their priorities. The
priority order is: Layer 2 and Layer 3 information > Layer 2 information > Layer 3
information. The traffic classifier with the highest priority is matched first.
l If the configuration order is used, traffic classifiers are matched in the order in which they
were bound to the traffic policy. The traffic classifier that was bound to the traffic policy
first is matched first.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic policy policy-name [ match-order { auto | config } ]
A traffic policy is created and the traffic policy view is displayed.
Step 3 Run:
classifier classifier-name behavior behavior-name
A traffic classifier is bound to a traffic behavior in the traffic policy.
----End
1.4.5 Applying the Traffic Policy
The configured traffic policy takes effect only after it is applied to the system, a slot, an interface,
or a VLAN.
Quidway S7700 Smart Routing Switch
Configuration Guide - QoS 1 Class-based QoS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28