Huawei quidway s7700 - Example for Configuring Traffic Distribution Based on ECMP

classifier test behavior test
#
interface Eth-Trunk1
load-balance diffluence
#
interface GigabitEthernet1/0/1
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface GigabitEthernet1/0/2
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface GigabitEthernet1/0/3
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface GigabitEthernet1/0/4
eth-trunk 1
undo negotiation auto
single-fiber enable
#
interface XGigabitEthernet2/0/1
traffic-policy test inbound
#
return
4.6.2 Example for Configuring Traffic Distribution Based on ECMP
Networking Requirements
As show in Figure 4-4, Switch A is connected to the upstream traffic splitter through XGE 2/0/1.
The traffic sent from the upstream traffic splitter enters Switch A through XGE 2/0/1. Then the
traffic is distributed on four GE interfaces and sent to four packet analysis servers. It is required
that packets from the same source reach the same destination.
Quidway S7700 Smart Routing Switch
Configuration Guide - QoS 4 Traffic Distribution Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
107