EasyManua.ls Logo

Huawei quidway s7700 - Page 113

Huawei quidway s7700
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
[SwitchA-Eth-Trunk1] load-balance diffluence
[SwitchA-Eth-Trunk1] quit
Step 2 Configure a traffic policy to redirect the UDP packets with the destination port number being
10000 to Eth-Trunk 1.
# Create ACL 3000 to match the UDP packet with the destination port number being 10000.
[SwitchA] acl 3000
[SwitchA-acl-adv-3000] rule 5 permit udp destination-port eq 10000
[SwitchA-acl-adv-3000] quit
# Define the traffic classifier test and configure ACL 3000.
[SwitchA] traffic classifier test
[SwitchA-classifier-test] if-match acl 3000
[SwitchA-classifier-test] quit
# Define the traffic behavior test and set the traffic action to redirection.
[SwitchA] traffic behavior test
[SwitchA-behavior-test] redirect interface eth-trunk 1
[SwitchA-behavior-test] quit
# Define the traffic policy test where the traffic classifier is bound to the traffic behavior.
[SwitchA] traffic policy test
[SwitchA-trafficpolicy-test] classifier test behavior test
[SwitchA-trafficpolicy-test] quit
# Apply the traffic policy to the inbound interface of traffic.
[SwitchA] interface xgigabitethernet 2/0/1
[SwitchA-XGigabitEthernet2/0/1] traffic-policy test inbound
[SwitchA-XGigabitEthernet2/0/1] quit
Step 3 Configure unidirectional single-fiber communication.
# Configure unidirectional single-fiber communication on GE interfaces connected to packet
analysis servers.
[SwitchA] interface gigabitethernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] undo negotiation auto
[SwitchA-GigabitEthernet1/0/1] single-fiber enable
# The configurations of unidirectional single-fiber communication on other GE interfaces are
similar to the configuration on GE 1/0/1, and are not mentioned here.
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
acl number 3000
rule 5 permit udp destination-port eq 10000
#
traffic classifier test
if-match acl 3000
#
traffic behavior test
redirect interface Eth-Trunk1
#
traffic policy test
Quidway S7700 Smart Routing Switch
Configuration Guide - QoS 4 Traffic Distribution Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
106

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals