[Switch] interface gigabitethernet1/0/1
[Switch-GigabitEthernet1/0/1] port hybrid pivd vlan 100
[Switch-GigabitEthernet1/0/1] port hybrid untagged vlan 100 300
[Switch-GigabitEthernet1/0/1] port vlan-stacking vlan 100 stack-vlan 300
[Switch-GigabitEthernet1/0/1] quit
[Switch] interface gigabitethernet1/0/2
[Switch-GigabitEthernet1/0/2] port hybrid pivd vlan 200
[Switch-GigabitEthernet1/0/1] port hybrid untagged vlan 200 300
[Switch-GigabitEthernet1/0/2] port vlan-stacking vlan 200 stack-vlan 300
[Switch-GigabitEthernet1/0/2] quit
[Switch] interface gigabitethernet2/0/1
[Switch-GigabitEthernet2/0/1] port link-type trunk
[Switch-GigabitEthernet2/0/1] port trunk allow-pass vlan 300
[Switch-GigabitEthernet2/0/1] quit
# Create VLANIF 300 and assign IP address 192.168.1.1/24 to VLANIF 300.
[Switch] interface vlanif 300
[Switch-Vlanif300] ip address 192.168.1.1 24
[Switch-Vlanif300] quit
Step 2 Create traffic classifiers.
# Create traffic classifiers c1 to c2 on the Switch to classify incoming packets based on the
VLAN ID in the inner VLAN tag.
[Switch] traffic classifier c1 operator and
[Switch-classifier-c1] if-match cvlan-id 100
[Switch-classifier-c1] quit
[Switch] traffic classifier c2 operator and
[Switch-classifier-c2] if-match cvlan-id 200
[Switch-classifier-c2] quit
Step 3 Create traffic behaviors.
# Create traffic behaviors b1 to b2 on the Switch to re-mark priorities of user packets.
[Switch] traffic behavior b1
[Switch-behavior-b1] remark 8021p 4
[Switch-behavior-b1] quit
[Switch] traffic behavior b2
[Switch-behavior-b2] remark 8021p 2
[Switch-behavior-b2] quit
Step 4 Create a traffic policy and apply it to an interface.
# Create traffic policy p1 on the Switch, bind traffic classifiers to traffic behaviors in the traffic
policy, and apply the traffic policy to GE 1/0/1 and GE 1/0/2 in the inbound direction to re-mark
priorities of packets coming from the user side.
[Switch] traffic policy p1
[Switch-trafficpolicy-p1] classifier c1 behavior b1
[Switch-trafficpolicy-p1] classifier c2 behavior b2
[Switch-trafficpolicy-p1] quit
[Switch] interface gigabitethernet1/0/1
[Switch-GigabitEthernet1/0/1] traffic-policy p1 inbound
[Switch-GigabitEthernet1/0/1] quit
[Switch] interface gigabitethernet1/0/2
[Switch-GigabitEthernet1/0/2] traffic-policy p1 inbound
[Switch-GigabitEthernet1/0/2] quit
Step 5 Verify the configuration.
# Check the configuration of traffic classifiers.
<Switch> display traffic classifier user-defined
User Defined Classifier Information:
Quidway S7700 Smart Routing Switch
Configuration Guide - QoS 1 Class-based QoS Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
36
To Next Page
Loading...
