Huawei RTN510 - RTN510 AP Aggregation Node VLAN ID Modification Example; RT Site DHCP Client Configuration Example; RTN510 AP Aggregation Node DHCP Server Configuration Example

HUAWEI TECHNOLOGIES CO., LTD.
Huawei Confidential
Page 11
Configuration Example
Configuration Example of the RT Site
1. Enable the DHCP client function on the RTN510 RT.
2. Enable the DHCP client function on the PowerCube 500.
1. Enable the DHCP server function, and configure the IP address pool and DHCP gateway IP address as
planned.
Configuration Example of the RTN510 AP on the Aggregation Node
2. Modify the management VLAN ID. (If the default VLAN 4094 is occupied, perform this operation.)