Huawei RTN510 - RTN510 AP Aggregation Node DHCP Server Configuration Example; RT Site DHCP Client Configuration Example

HUAWEI TECHNOLOGIES CO., LTD.
Huawei Confidential
Page 9
Configuration Example
Configuration Example of the RT Site
1. Enable the DHCP client function on the RTN510 RT.
2. Enable the DHCP client function on the PowerCube 500. That is, refer to
step 3 in slide 4 to set the corresponding parameter to Enable.
Enable the DHCP server function, and configure the IP address pool and DHCP
gateway IP address as planned.
Configuration Example of the RTN510 AP on the Aggregation Node