CCLINUX
USER Manual
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Figure 4-7-1
1） Automatic detection, plug the parallel port self-test device, click "Start", parallel port
automatically start testing.
2） Check the "manual inspection", select the register address and enter the value, start reading
and writing test.
2.4.8 Serial Test Tools
1. Introduction:
You can set the serial port, baud rate, parity bit, data bit, stop bit, to communicate with the serial
device; this feature is limited to the root user permissions.
2. Operating procedures:
Click "Start" -> "System Tools" -> "Serial Test Tools", the running interface shown in Figure 4-8-1:
To Next Page
Loading...
