CCLINUX
USER Manual
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
As shown in the figure, select the type of network (use Ethernet as an example) to select
"Ethernet", then click the "Create…" button, the running interface is shown in Figure 5-3-4. You can
set the network connection name, general settings, Ethernet, 802.1X security, IPv4 settings, IPv6
settings.
Figure 5-3-4
2.5.4 Restore Configuration
1. Introduction:
Use the "Restore Factory" to restore all parameters to the factory state; this feature is limited to
root.
2. Operating procedures:
Click "Start" -> "Preferences" -> "Restore Configuration", the running interface is shown in Figure
5-4-1:
To Next Page
Loading...
