● Do not install the inverter in areas with ammable materials.
● Do not install the inverter in areas with explosive materials.
● Do not install the inverter in areas with corrosive materials.
● Do not install the inverter where its enclosure and heat sink are easily
accessible, because the voltage is high and these parts are hot during
operation.
● Install the inverter in a well-ventilated environment to ensure good heat
dissipation.
● If the inverter is installed in an enclosed environment, a heat dissipation
device or ventilation device shall be installed. The indoor ambient
temperature must not be higher than the outdoor ambient temperature.
● You are advised to install the inverter in a sheltered area or install an awning
over it.
● If you need to install the inverter outdoors in
salt-aected areas that may
cause corrosion, contact technical support. A salt-aected area refers to a
region within 500 m of the coast or prone to sea breeze. Regions prone to sea
breeze vary with weather conditions (such as typhoons and monsoons) or
terrains (such as dams and hills).
SUN2000-(250KTL, 280KTL, 300KTL, 330KTL) Series
User Manual 4 Installation
Issue 07 (2023-06-30) Copyright © Huawei Technologies Co., Ltd. 28
To Next Page
Loading...
