Procedure
Step 1 Remove the AC terminal box and installing partition boards.
Figure 5-5 Removing the AC terminal box
Step 2 Connect the AC output power cable.
● Do not route a cable with a crimped OT terminal directly through the rubber liner.
Otherwise, the liner may be damaged.
● Reserve sucient slack for the PE wire to ensure that the PE wire is the last cable
bearing the force when the AC output power cable is subject to a pulling force due to
force majeure. It is recommended that the stripping length of the PE cable be 15 mm
longer than that of other cables.
● The cable colors shown in the gures are for reference only. Select an appropriate cable
according to the local standards.
Figure 5-6 Stripping an AC power cable (using a ve-core cable as an example)
SUN2000-(20KTL, 29.9KTL, 30KTL, 36KTL, 40KTL)-
M3
User Manual 5 Electrical Connections
Issue 18 (2024-03-10) Copyright © Huawei Technologies Co., Ltd. 45
To Next Page
Loading...
