6
1. Remove the power distribution unit
cover from the rear of the chassis.
2. Remove covers from the cabinet
bottom based on the number and
positions of cables.
3. (Skip this step if the mains input and bypass
input share a power source.) Remove the
copper bars between the mains input and
bypass input.
Connecting Cables
3.2
Signal cable
4. Connect the ground cable, power cables, and signal cable.
The number of cables in the figure is
for reference only.
If the mains input and bypass input
share a power source, you do not
need to connect bypass input cables.
To Next Page
Loading...
