Pitch
Every standard rigger comes out of the factory at 0 degrees stern pitch, and 0 degrees lateral.
Using pitch bushings (CII) you can set the pitch from 1 degree through 7 degrees.
Every oarlock comes with 4 degrees inserted, which is usually a good place to start, unless you
know what pitch you use. Most oar manufacturers will have a recommended pitch for their
oars.
Tip: You can use the pin to extract a tight fitting bushing. Slide the oarlock up the pin until the
bottom of the top bushing clears the top of the pin. Press the top of the oarlock towards the
stern with one hand and press down with the other. It’s effective, and a lot safer than stabbing
at it or yourself with a screwdriver. (See photos below)
To Next Page
Loading...