SCULLING
Sculling riggers have two numbers stamped on them which gives the height in centimeters from
the foot to the top of the pin block, and the depth of the rigger from the rigger cross piece to
an imaginary line between the bowsides of the pin blocks measured in inches (see stamping
below left).
The best way to measure the rigger off the boat is to find a level floor, press down inbetween
the boat mounts, and measure from the floor up to the top of the starboard pin block(see
below right). This measurement is in centimeters.
To measure the depth of the rigger put the rigger upright on the pin blocks on a level floor,
and measure from the cross piece to the floor. This measurement is in inches.
To Next Page
Loading...