To move the steering from the stroke seat to the bow seat:
• Loosen the ¼” bolt on the back of the toe with a 7/16” wrench.
• Draw the cables out of the toe, cable termination blocks, and the sleeving.
• Use the two shortest sleeves to bridge from the stroke cable termination block to the
bow redirect cable termination blocks (Please Note: The cable termination blocks are
not symmetric. One side is bored out enough to house the sleeve, the other side is big
enough for the cable to be routed through)
• Rout the cable through (see photo below)
• Move the stroke shoe assembly to the bow seat, and the bow shoe assembly to the
stroke seat.
• Use the longer sleeving to bridge the starboard bow cable termination block to the
steering foot assembly, and the shorter to bridge the port side.
• Rout the cable through the cable termination blocks, and the sleeving (Please note:
Straight fours will have additional cable guides)
• Thread the cable through the toe and adjust the steering as needed (See photo below)
To Next Page
Loading...