Huffy BMX - Gyro Brake and Stem Setup

12
Gyro Stem and Brake Setup
• Make sure Rear Brake Cable Sheath
A
is
fully inserted into the adjustment Housing
at the Caliper and Hand Lever
B
.
• Ensure Housing Nut and Housing (B, C) are
adjusted all the way in towards the Hand
Lever.
• Rotate Housing
B
Groove away from Cable
Groove
D
and tighten Housing Nut
C
.
A
B
D
C
continued >>
Stem and Handlebar Setup - Gyro Brake
Note: The Handlebar Stem Clamp may be pre-installed from the factory.
3 1
2 4
B
C
A
• Carefully unpack Handlebar
A
and Brake
Cables.
• Install the Handlebar using Clamp
B
and
Clamp Screws
C
.
• Rotate Handlebar into a comfortable riding
position.
• Tighten Clamp Screws
C
securely. See
Torque Chart for recommended torque.
Assembly