4.
Insert Tip into the front of the main body until the magnet inside the main body holds the Tip.
5.
Secure the Front Cap to the main body passing through the fiber carefully.
6.
Check that the cannula comes out straight from the main body as below. If it comes out bended
or the Tip is encumbered, straighten the cannula and re-install the Front Cap.
If the Front Cap is installed properly, you may adjust the cannula
length for the appropriate procedure. You may bend the Front Cap
up to 70°for your convenience.
Caution
Do not separate the Front Cap while it is bent. The Tip may break. When separating the
Front Cap from the main body, hold the Tip cap straight and then remove.
18
To Next Page
Loading...
Need help?
General