Hulaser K Series User Manual

8. TROUBLESHOOTING AND REPAIRS
8-1 Troubleshooting
When the program works incorrectly, remove the battery to restart the device. Wait for 5 seconds and then
re-install the battery. If the problem is not solving after restarting the device, the system cannot be used
until the cause of the error has been remedied. Call Hulaser or the Hulaser Service Representative.
8-2 Malfunctions and Error messages
Malfunction Display
Temperature too high
Cause
Solution
The temperature of the
laser module is too high
Set the device in Standby
mode to get cooler and
reactivate the laser after a
while.
8-3 Repairs
Do not repair the device arbitrarily. Doing so may void the product limited warranty.
If you want to have the repair service, call Hulaser at +82-2-3012-5678 (email: info@hulaser.com)
or the Hulaser Service Representative.
33

Hulaser K Series Specifications

General

Brand	Hulaser
Model	K Series
Category	Dental equipment
Language	English