Video Switch
Two options are available: Input and Output. Selecting
Input allows you to switch the image source between
the camera and VGA IN. Selecting Output allows
you to toggle between the LCD screen mounted on
the arm (if present) and a monitor connected on the
VGA OUT port. In both cases, changing selection is
done by pressing and holding the
Page Locator
button for 2 seconds (Advanced control panel only).
Video Switch settings will be saved when the system
is shutdown.
Note that on the base configuration where an LCD
screen cannot be attached, the
Video Switch
para
meter cannot be changed to Output. Any attempt to
do so will result in an error beep.
PC@Screen video link
Turn this option on if you wish to send the VGA IN
signal to the screen when unit is turned off. This is
useful if your computer is connected to the VGA IN
port and you wish to display its image on the screen
without modifying video connections.
4 Using VGA IN, VGA OUT
and TV Output
The SmartView Synergy offers different video options.
18
To Next Page
Loading...
