If the Page Locator light does not appear:
• Remove any objects from the reading table and
then see if the Page Locator light is visible
against the surface of the table.
• Certain colors found on your reading material
may camouflage the light of the Page Locator.
It is best seen on white paper.
If there is a limited number of false colors:
• Press the Enhanced contrast button to make
sure that the SmartView Synergy is in Enhanced
contrast mode.
• Press and hold the
Enhanced contrast
button
for five seconds until you hear a beep.
If you are stuck in the menu:
• Press the Enhanced contrast button.
• Press the Power button to switch off the
machine, then press the
Power
button again
to switch on and restart.
If the Start@Up screen stays on:
• Press the Power button to switch off the
machine, then press the
Power
button again to
switch on and restart.
• Contact dealer or technical support.
24
To Next Page
Loading...
