Rear Seats
Rear Seat Operation
Entering or Exiting the Third Row
Seats
To enter or exit the third row seat (if equipped) you
must fold the second row seat down following the
instructions later in this section. See “Folding the
Seatbacks” under 60/40 Split Bench Seat on page 1-8.
If you are exiting the third row seat with no assistance,
do the following:
1. Reach over the second
row seat and pull up on
the strap loop. Then
pull the seat cushion up
and push it forward.
2. Next, push the seatback forward until it is flat with
the floor.
Be sure to return the seat to the upright position when
finished. Pull forward and push rearward on the seat
to make sure it is locked in place.
{CAUTION:
If the seatback isn’t locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward on the seatback to be sure it is
locked.
1-7
To Next Page
Loading...
Need help?
General
