Sunroof
Your vehicle may be equipped with a power sliding
sunroof. To operate your sunroof, the ignition needs to
be on or RAP needs to be active. See “Retained
Accessory Power” under Ignition Positions on page 2-19.
The switch used to operate the sunroof is located in
the overhead console.
The sunroof is equipped with five positions:
• First open stop: To open the sunroof and
sunshade, press and hold the rear side of the switch
until the sunroof reaches the desired position or
until it reaches the first open stop. For more
information on using the sunshade, see “Sunshade
Operation” later in this section.
• Second open stop: To open it further, press and
hold the rear side of the switch until the sunroof
reaches the desired position or until it reaches the
second open stop.
• Fully open: To open the sunroof completely, press
and hold the rear side of the switch until the
sunroof opens completely.
• Closed: To close the sunroof, press and hold the
front of the switch until the sunroof reaches the
desired position or until it is fully closed and stops
on its own. The sunroof will not be fully seated
unless the switch is held until the sunroof stops
moving.
2-50
To Next Page
Loading...
Need help?
General
