Removing the Flat Tire and Installing
the Spare Tire
1. To remove the center
cap, place the flat end
of the wheel wrench
in the slot on the wheel
and gently pry the
center cap out.
2. Slide the ratchet onto the wheel wrench with the
DOWN mark facing you.
3. Turn the ratchet counterclockwise to loosen the
wheel nuts. Don’t remove them yet.
You will now need to jack the vehicle up using the
instructions following.
4. Assemble the jack and tools as follows:
Front Flat Tire: Attach the jack handle (E) with the
hook end connected to the u-hook/clevis on the
jack (A). Slide the ratchet (F) onto the jack handle (E)
with the UP mark facing you.
5-83
To Next Page
Loading...
