1
Introduction
We encourage you to read this manual carefully in order to understand
360 Imaging and how to use this Humminbird advanced accessory on the water.
Some of the equipment requirements and menu options depend on the type of
mount you have installed. Whether you have a Transducer Deployment System or a
Trolling Motor Mount, every effort has been made to clearly identify those features
throughout this manual.
Important Information
Before you use the 360 Imaging transducer on the water, it is important to
understand the following:
SPEED
The 360 Imaging transducer pod can be used in the water at 0 to 7 mph. The
transducer pod should NOT be in the water during high speed travel.
OBSTRUCTIONS
Be aware of obstructions in the water that could damage the transducer pod.
Also be aware of bridges or anything above the boat that could damage the
Transducer Deployment System.
MAINTAINING POWER
The Transducer Deployment System must stay powered ON while the boat is
underway to keep the pod retracted and fully stowed.
POWERING OFF
When the boat is at dock or in storage, the 360 Imaging transducer should be
turned off to prevent draining the battery. See Power Off for more information.
POD COVER
The pod cover must be installed on the Transducer Deployment System for
trailering and storage. See Power Off for more information.
SETTING UP THE CONTROL HEAD
The control head must be set up correctly to add the 360 Imaging features to the
Menu System and View Rotation. See Set up the Network and 360 Imaging
Alarms.
LLLLL
L
Introduction
To Next Page
Loading...
