8
42798-01 • 12/28/09 • Hunter Fan Company
8
Place the slots over the hooks to hang the fan.
Remove the pin from the pipe, then slide the wedge o the pipe.
Remove the pipe ball screw from the standard pipe/ball assembly, then
slide the ball o the pipe
Optional Pipe/Ball Instructions:
Optional Pipe/Ball Instructions: Optional Pipe/Ball Instructions:
3.6
3.8
3.5
3.7
Pipe Ball
Screw
Ball
Pipe
Extension
Pipe
Pipe
Wedge
Pin
3 • Assembling and Hanging the Fan (continued)
Your Hunter fan comes with an optional pipe/ball assembly extension
pipe. If you would like to use the enclosed optional 6 inch pipe/ball
assembly, follow Steps 3.6-3.9. Note: e Auto Balance
TM
system is
designed for pipe/ball assemblies that are 6” and shorter. If you use a pipe/
ball assembly longer than 6 inches, do not activate the Auto Balance
TM
system.
To Next Page
Loading...
