Hunter 20578 - Installing the Ceiling Plate Cover

13
42798-01 • 12/28/09 • Hunter Fan Company
13
6 • Installing the Ceiling Plate Cover
Swing the fan up to align the ceiling mounting plate cover screw holes with
the mounting holes on the ceiling mounting plate(2).
Partially install (about 2 full turns) the three ceiling mounting plate cover
screws (62) into the ceiling mounting plate. Once all three screws are in,
tighten them.
62
2
3
3
6.2
6.1
6.3 6.4
Using both hands, push the ceiling mounting plate cover trim ring (4) up
to the top of the ceiling mounting plate cover. e ceiling mounting plate
cover trim ring will snap and lock into place.
3
4
Should you need to remove the trim ring, press rmly on opposite sides of
the trim ring (4). e tabs will ex out releasing the ceiling mounting plate
cover trim ring (4).
3
4