14
42798-01 • 12/28/09 • Hunter Fan Company
14
7 • Assembling the Blades
Attach each blade (46) to a blade arm (44) using three blade assembly
screws (67). e blades may appear slightly loose after screws are
tightened. is is normal.
Squeeze the rubber blade grommets (66) into the holes in the blades (46).
66
67
44
46
46
7.1 7.2
44
47
47
7.47.3
Loosen (DO NOT REMOVE) the blade-to-arm screws (47) that are holding
the shipping bumpers in place. Push the shipping bumpers in, then lift
them o.
Slide the blade arms (44) onto the blade-to-arm screws (47). Tighten the
blade-to-arm screws (47) as tight as possible with a screwdriver.
To Next Page
Loading...
