15
42798-01 • 12/28/09 • Hunter Fan Company
15
Note: After the
retaining screws
are removed,
the blades will
feel loose. is
is normal, as
loose blades are
a characteristic
of the Auto
Balance
TM
system.
8.1
8.2
If you are using one of the enclosed pipe/ball assemblies, it is now time
for you to activate the Auto Balance
TM
system by removing the ve red
retaining screws. Rotate the blades slowly until one of the red retaining
screws is visible through the notch in the mounting plate. Remove the
retaining screw from the bottom of the fan housing using a screwdriver.
Repeat this process for all 5 retaining screws.
If you are using a pipe/ball assembly longer than 6 inches, leave the
retaining screws in their place and continue the installation process.
Red Retaining
Screws
8 • Activating Auto Balance
TM
To Next Page
Loading...
