9
42798-01 • 12/28/09 • Hunter Fan Company
9
4 • Setting the Remote Transmitter and Receiver
4 • Setting the Remote Transmitter and Receiver
87
86
e DIP switches for the receiver (86) are located on the at surface
of the receiver. e jumpers for the transmitter (87) are in the battery
compartment.
Reassemble the ground wire, wedge, pin, ball, and pipe ball screw, in that
order, onto the long pipe/ball assembly. Go back to Step 3.2.
IMPORTANT! Before you change the DIP switch settings, make sure the
battery is not connected to the transmitter. Also, make sure the power is
still o.
Remove the screw and ground wire from the pipe.
3.10
3.9
4.1
Optional Pipe/Ball Instructions: Optional Pipe/Ball Instructions:
3 • Assembling and Hanging the Fan (continued)
Screw
Ground Wire
To Next Page
Loading...
