21
42798-01 • 12/28/09 • Hunter Fan Company
Troubleshooting
Problem: Nothing happens; fan does not move.
1. Turn power on, replace fuse, or reset breaker.
2. Loosen canopy, check all connections according to the wiring the
fan section.
3. Check the plug connection in the switch housing.
4. Push motor reversing switch rmly left or right to ensure that the
switch is engaged.
5. Pull the pull chain to ensure it is on.
6. Remove the shipping bumpers.
Problem: Noisy operation
1. Tighten the blade assembly screws and blade iron armature screws
until snug.
2. Check to see if the blade is cracked. If so, replace all the blades.
Problem: Excessive wobbling
1. If your fan wobbles when operating, use the enclosed balancing
kit and instructions to balance the fan.
2. Tighten all blade iron screws.
3. Turn power o, support fan very carefully, and check that the
hanger ball is properly seated.
Problem: Lights turn off when installed or dim when turned
on
1. Check to make sure the wattage and type of light bulbs installed
match the specications on the light socket.
Problem: Lights shut off suddenly
1. Turn the power to the fan o at the wall switch. Wait 30
seconds, then resume power to the fan.If you have tried these
troubleshooting solutions and still
have trouble, visit our Web site at:
http://www.hunterfan.com.
Hunter Fan Company
7130 Goodlett Farms Parkway #400
Memphis, Tennessee 38016
Operation
e fan pull chain controls power to the fan.
• e pull chain has four settings in sequence: High, Medium,
Low, and O.
• Pull the chain slowly to change settings.
• Release slowly to prevent the chain from recoiling into the
blades.
• e chain uses a breakaway connector that separates if the
chain is jerked. If this happens, simply reinsert the chain into
the connector.
e light pull chain controls the power to the light fixture.
• e chain has two settings: ON and OFF.
11 • Operation & Maintenance
Cleaning and Maintenance
Caring for nishes:
For cleaning nishes, use a soft brush or lint-free cloth to prevent
scratching. A vacuum cleaner brush nozzle can remove heavier
dust. Remove surface smudges or accumulated dirt and dust
using a mild detergent and a slightly dampened cloth. You may
use an artistic agent, but never abrasive cleaning agents as they
will damage the nish.
Caring for blades:
Note: Be careful to not bend the blades when cleaning.
Clean wood nish blades with a furniture polishing cloth.
Occasionally, apply a light coat of furniture polish for added
protection and beauty. Clean painted and high-gloss blades in the
same manner as the fan nish.
To Next Page
Loading...
