Hunter 23902 - Uninstalling the Light Fixture

15
42776-01•04/29/08•HunterFanCompany
8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
8-17. Touninstallthelightxture,rstdisconnecttheplugconnectors
between the black wire and the black/white wire.
8-18. Disconnecttheplugconnectorsbetweenthetwowhitewires.
8-19. Removethetwoscrewsattachingthelightkittothelower
switch housing.
8-20. Removethelightxturefromthelowerswitchhousing,pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through first, and then pull the other plug connector
(female) through the hole.
8-21. Installthedummyterminals(includedinthesackparts)onthe
two disconnected wires in the lower switch housing.
8-22. Installtheswitchhousingcapandplugbuttontothelower
switch housing.
8-23. Onceyouhaveuninstalledthelightxture,continue
 withstep8-6.
Male Dummy
Terminal
Female Dummy
Terminal
Step 8-22
Cap
Plug Button
Step 8-19
Lower Switch
Housing