Hunter 23902 - Installing the Glass Bowl and Pull Chains

14
42776-01•04/29/08•HunterFanCompany
8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Installing the Glass Bowl
8-8. FirstinstallB10candelabrabulbs(60WattMaximum)intothe
sockets.
8-9. Ifthefandangleisattachedtotheextrapullchain,removeitnow.
8-10. Attachtheextrapullchain(included)tothefanpullchainusing
the plastic breakaway connector. (You may find the plastic
breakaway connector on the end of the extra chain.)
8-11. readthefanpullchainthroughtheholeinthemetaldisc.en,
thread the fan pull chain through the hole in the center of the glass
bowl.
8-12. readthelightpullchainthroughtheholeinthecenterofthe
glass bowl. en, read the light pull chain through the hole in
the center of the cover plate.
8-13. readthefanpullchainthroughthegrommetholeinthesideof
the cover plate.
8-14. Placethecoverplateupagainstthe
glassbowl.Aligntheholesinthecover
plate and glass bowl.
8-15. readthelightpullchainthrough
the finial and screw the finial onto the
threaded rod end until tight.
8-16.Reattachthefandangletotheextrapull
chain.
Breakaway
Connector
Light Bulb
Sockets
(B10
Candelabra-
Based 60 Watt
Maximum)
MetalRod
Metal Disc
GlassBowl
Cover Plate
Finial