15
PROGRAMMING
Auto Recovery selection
■ or to enable “YES” or disable “NO” the
Auto Recovery Mode. The factory setting is “YES.”
■ To change between Heat or Cool recovery modes.
NOTE: Auto Recovery is one of the ENERGY STAR
®
features of this thermostat. Refer to the Auto Recovery
section on pages 43-44 for more information.
Remote Sensor Channel (does not apply to thermostat model 44660)
■ to reach the Sensor Channel Set screen.
■ to select sensor for RF channel setting ( for Indoor 1,
for Indoor 2, or for Outdoor)
option
7
option
sensor
8
1
2
To Next Page
Loading...
