Sails and Rigging
12.16
STEP ONE
PIN LOWER END OF STRUT TO FWD CHAINPLATE HOLE AND ADD
SPLIT RINGS
STRUT
(RD-1 ATTACHES HERE)
JAM NUTS
INNER CHAINPLATE
(UPPER STRUT MOUNT
ON EA. SIDE OF MAST)
STEP TWO
ADJUST THREADS UNTIL BALL ROD JOINT IS ABLE TO BE EASILY PINNED
IN STRUT BRACKET
STEP THREE
PIN BALL ROD JOINT AND TIGHTEN JAM NUT AGAINST END OF STRUT &
BALL JOINT ROD
STEP FOUR
ENSURE ALL JOINTS, PINS, JAM NUTS ARE SECURED
BALL ROD
JOINT
(D-1 ATTACHES
HERE)
FWD
AFT
WE DO NOT RECOMMEND BOAT OWNER
TO PERFORM THIS INSTALLATION PROCEDURE.
ALWAYS REFER TO YOUR LOCAL DEALER OR
HAVE QUALIFIED TECHNICIAN TO PERFORM
THIS PROCEDURE.
MAST UPPER SPREADER TIP DETAIL
MAST LOWER SPREADER TIP DETAIL
Figure 12.13 Strut Information
Figure 12.14 Spreader
Tip Information
To Next Page
Loading...
