3
This section will give you a brief description of
the components of the ROAM. Each item will be
discussed in further detail later, however this
section can be helpful in getting acquainted with the
Transmitter, Receiver, and SmartPort
®
.
TRANSMITTER
A. LCD Display
1.
Run Time – Indicates the station run time
is being set.
2.
Transmit – Indicates that the transmitter
is transmitting the programmed data to the
receiver.
3.
Station Number – Indicates station
number (1 to 240).
On – Indicates Transmitter is turning on a
particular station.
Off – Indicates Transmitter is turning off a
particular station.
PA, PB, PC – Indicates program selected.
4.
Address – Indicates that a new address
for transmitting between the Transmitter and
the Receiver is being set.
B. Control Buttons
5.
– Increases the selected functions.
6.
– Decreases the selected functions.
7.
– Selects the selected functions.
8.
– Cancels the selected functions.
9.
– Scrolls between functions.
C. Other
10. Battery Cover – Covers compartment for four
AAA alkaline batteries.
To Next Page
Loading...
Need help?
General
