2 1. Getting Started Operation Instructions for TCX575 Tire Changer
To reduce the risk of fire, do not operate the equipment in the vicinity of open
containers of flammable liquids (gasoline).
Do not operate the equipment with a damaged cord or if the equipment has been
damaged - until it has been examined by a qualified serviceman.
If an extension cord is necessary, a cord with a current rating equal to or more than
that of the equipment should be used. Cords rated for less current than the
equipment may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
Always unplug equipment from electrical outlet when not in use. Never use the cord
to pull the plug from the outlet. Grasp plug and pull to disconnect.
Read and follow all caution and warning labels affixed to equipment and tools. Keep
all decals, labels, and notices clean and visible.
Read and understand all instructions before operating this machine.
Misuse of this equipment can cause personal injury and shorten the life of the tire
changer.
To prevent accidents or damage to the tire changer, use only Hunter recommended
procedures and accessories.
Wear OSHA approved eye protection while operating the tire changer.
Wear non-slip safety footwear when operating the tire changer.
Do not wear jewelry or loose clothing when operating the tire changer.
Wear proper back support when lifting or removing wheels from the tire changer.
WARNING: Keep hands and clothing clear of moving parts.
Do not lean or reach over tire when inflating.
Never stand on the tire changer.
WARNING: Do not exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi.
• Operating pressure (gauge on regulator) is 145 psi.
• Bead seating pressure (gauge on hose) is the tire
manufacturer’s maximum pressure as stated on the
sidewall of the tire.
Mixing tire and rim sizes may affect steering, handling, and the braking of the vehicle.
Keep hands and clothing clear of moving parts.
DANGER: Activate air inflation jets only when sealing bead.
Bleed air pressure from system before disconnecting supply line or other pneumatic
components. Air is stored in a reservoir for operation of inflation jets.
WARNING: Only activate the air inflation jets if the rim securing
device is locked in place and the tire is properly
clamped (when possible).
To Next Page
Loading...
