Operation Instructions for TCX575 Tire Changer 2. Basic Procedures 13
2.2 Placing Wheel on Tire Changer
Identify and recognize special wheel combinations such as Reverse Drop Center
(needs inverted on changer), AH, “Run-Flat” Extended Mobility Tires, and standard
tires with pressure sensors.
Clamping the Wheel from Inside of Rim - Steel Rims
Identify the inner locations on the rim where the clamps will come in contact.
Position the clamps in the fully retracted position (clamps completely in).
Place the wheel centered onto the turntable.
Step down on the clamping pedal to expand the clamps to the rim.
NOTE: Avoid clamping inside
rim of alloy wheels. Steel jaws
may damage the finish of inside rim surface during use.
Verify that the wheel has been properly clamped and centered.
Clamping the Wheel from Outside of Rim - Alloy Rims
Place the clamping pedal in the stopped position by partially stepping down
on the pedal with the clamps expanding or in the fully expanded position.
From this stopped position, use additional partial steps on the clamping pedal to
incrementally retract the clamps. Set the clamps to the mark on the turntable that
corresponds to the size of rim to be clamped (12”- 14” - 16”).
Place the wheel onto the turntable.
Continue to incrementally retract the clamps until all four clamps contact the rim.
Step down once only on the clamping pedal to fully retract the clamps to the
rim.
NOTE: Always verify that all four clamps are on the rim before
applying pressure to prevent possible failure.
Plastic jaw covers may be used to help maintain rim protection when clamping
externally. Plastic jaw covers may be replaced periodically when worn by ordering
kit RP11-8-11400085 which contains 2 sets of plastic covers.
2.3 Demounting Standard Tire from Rim
Top Bead Demounting
Position the mount/demount head against the outer edge of the upper rim lip. The
plastic surfaces should contact the rim lip.
Slide the mount/demount head in or out along the upper rail and lower the head into
position. Push the button on handle to lock head into position. The mount / demount
head will automatically build in the proper spacing.
To Next Page
Loading...
