Operation Instructions for TCX575 Tire Changer 2. Basic Procedures 17
Raise the BPS disc, and then rotate.
Precautionary Notes
When basic procedures are NOT followed, sharp angled wheel flanges increase
potential damage to tires during mounting. Be sure the mounting head is placed on
the rim with sufficient gap between the bead and bead seat. If the tire is incorrectly
pushed onto the rim by the side of the mounting head, it may become “trapped” and
increases mounting stress to the tire bead.
Insufficient lubrication and failure to place tire into drop center during mounting may
also cause the mount/demount head to fail prematurely.
Bottom Bead Demounting with Tool Head
Position the tire on the rim assembly as shown below. Insert the automatic lever into
the rim / tire assembly.
Lift the tire up and over the automatic lever and raise the automatic lever to lift the
lower bead.
NOTE: Alternatively, you may lift the tire up first, lower the automatic
lever, lift the tire into place and then lower the automatic
lever beneath the bottom bead.
To Next Page
Loading...
