16 2. Basic Procedures Operation Instructions for TCX575 Tire Changer
Press the wheel rotation pedal to rotate the wheel clockwise and fully
demount the upper bead.
Some of the more difficult tires may not allow for proper insertion of the automatic
bead lever because not enough of a gap can be created between the tire and the rim
edge.
NOT ENOUGH
GAP BETWEEN
TIRE AND RIM
EDGE
If this is the case, reposition the upper BPS disc as shown below. Lower the upper
BPS disc and push down to create a gap between the tire and the rim edge (A), then
insert the automatic bead lever (B).
(A)
PUSH DOWN
AT THIS POINT
(B)
INSERT
AUTOMATIC
BEAD LEVER
To Next Page
Loading...
