HunterDouglas LiteRise - Product View - LiteRise, SimpleLift, and UltraGlide

Complete the Installation
Attach the Wand (If Ordered)
If the blind was ordered with a wand tilter, attach the wand to the metal
shaft. Note: Wands may appear different from the illustration, but assembly is
the same.
• Pull the plastic sleeve from the top of the wand and insert it over the
metal shaft.
• Insert the hook on the wand through the hole in the metal shaft.
• Slide the plastic sleeve down over the hook until fi rmly seated.
• Test the wand tilter. Approximately six revolutions of the wand should tilt
the slats from fully closed up to fully closed down.
3
Attach the Valance (No Dust Cover)
Wood Blinds
• Tilt the valance to insert its
bottom notch into the bottom
part of the valance clip.
• Pulling the valance slightly
downward, insert the top
notch of the valance into
the clip, as shown.
• To remove the valance,
pull down on the valance
and pull out.
Bottom
Notch
Attach the Valance (With Dust Cover)
Wood Blinds Only
• Slide the valance dust cover onto the cornice clips, as shown in the illus-
tration below.
• If the blind is mounted to a door, secure the dust cover with a
1/4" wood screw through the slot in the cornice clip.
Valance
Dust Cover
Cornice Clip
Door Mounts
Only:
Secure with 1/4"
Wood Screw
Attach the Valance Returns, If Necessary
If the valance came with returns and they are not already attached, connect
the returns to the valance using the corner clips provided.
Wood Blinds
• The notches on the rear of the valance and returns fi t into the grooves of
the corner clips.
• Slide the wider side of each clip onto the
rear of the valance so that the shorter side
aligns with the edge of the miter cut at
each end.
• Slide a return onto each corner
clip until its miter is fl ush
against the miter on the
valance.
Plastic
Sleeve
Hook
Metal Shaft
Wand
Attached
Insert
Over
Shaft
Wand
Hook
Through
Hole
Alternative Wood Blinds
• The tabs on the corner clips fi t into
the notches on the valance, as shown
at right.
• Slide the valance and returns onto
the clips.
Miters
Meet
Corner
Clip
V
alance
Valance
Return
(Cross-
Section)
Notch
Notch
Alternative Wood Blinds
• Tilt the valance to
insert the notch at
the top into the upper
part of the valance clip.
• Then snap the lower part
of the valance into the clip.
• To remove the valance,
reach behind the lower edge
of the valance and locate the
plastic clips. Hold the valance
securely and gently pull each
clip away from the valance.
Top
Notch
Top
Notch
Bottom
Notch
Tabs Fit Into Notches