To Next PageTo Next Page
Need help?Do you have a question about the HunterDouglas Luxaflex PowerView and is the answer not in the manual?
General| Brand | HunterDouglas |
|---|---|
| Model | Luxaflex PowerView |
| Category | Window Blinds |
| Language | English |
Information on whether remotes or hubs are included or sold separately.
Guidance on waking the blind from hibernation and initial charging.
Procedure for waking, charging, and LED status during charging.
Details LED signals for normal charging, fully charged, and disallowed charging.
Step-by-step guide to pair a PowerView® remote with the blind.
Explanation of LED signals for charging states.
Selecting group 1 on the remote during the pairing process.
Initiating pairing mode by holding the manual control button.
Pressing the open button as part of the pairing sequence.
Completing the pairing by releasing the manual control button.
Procedure for the remote to exit programming mode.
Methods for selecting single, multiple, or all blinds.
Procedure to select all blinds for operation.
Choosing the desired blind group before opening or closing.
Activating the open function for the selected blind group.
Activating the close function for the selected blind group.
Selecting the blind group to move to a favorite position.
Activating the favorite position command for the selected blind.
Choosing the specific blind or group to set a favorite position.
Using remote buttons to adjust the blind to the target favorite position.
Initiating favorite position programming by holding the stop button.
Activating the blind's manual control button to set the favorite.
Confirming the favorite position by pressing the favorite button.
Completing the favorite position setting by releasing the button.
Confirmation that the favorite position has been successfully set.
Procedure for setting a new top limit for the blind.
Initiating the top limit adjustment process by holding the manual control button.
Pressing the open button to enter top limit programming mode.
Finalizing the entry into top limit programming mode.
Adjusting the blind's position to set the new top limit.
Saving the new top limit by holding the stop button.
Re-entering programming mode for finalization of top limit.
Confirming the new top limit setting by pressing the open button.
Initiating the bottom limit adjustment process by holding the manual control button.
Pressing the close button to enter bottom limit programming mode.
Finalizing the entry into bottom limit programming mode.
Adjusting the blind's position to set the new bottom limit.
Saving the new bottom limit by holding the stop button.
Steps to finalize bottom limit, confirm setting, and exit programming modes.
Confirmation that the new bottom limit has been successfully set.
Procedure to reset all end limits to factory default settings.
Instruction to skip the reset procedure for motors fresh out of the box.
Disconnecting power by inserting the USB-C connector into the motor head.
Holding the manual control button during power removal for reset.
Re-applying power while holding the manual control button to initiate reset.
Releasing the button after the motor jogs once to confirm reset.
Starting network reset by holding the manual control button for 12 seconds.
Completing the network reset upon the second motor jog.
Indicates LED status for Roller and Twist® Roller blinds.
Details LED signals for end limits and network reset operations.
Indicates LED signals for motor errors like obstruction or program mode.
