Programming Groups
hunterdouglas.com 5
BEFORE YOU BEGIN
Partially lower or tilt the
window covering.
PROGRAM BUTTON
Use a paper clip to press
and quickly release the
PROGRAM button on the back
of the remote control. The
indicator light at the top of
the remote will blink green for
approximately 30 seconds.
GROUP NUMBER
While the indicator light
is blinking green, press
the GROUP number to
which you are adding the
window covering.
UP BUTTON
Point the remote at the receiver
eye (either built into the headrail
or on a satellite eye) of the
window covering and press the
UP button. The unit will raise or
“jog” to show that it has been
programmed into the remote
control. Repeat steps to program
other window coverings.
1
2
3
To Next Page
Loading...
