2-4 Introduction to Your LabScan XE System 01/03
Options and Sample Devices
There are many options and devices available for positioning samples at the measurement port of the
LabScan XE and for making the instrument easier to use. Any or all of the following options and
sample devices may be included with your LabScan XE. HunterLab part numbers are included for your
convenience in ordering.
• Automated variable sample illumination (Option must be purchased with the instrument),
• Automated UV control (Option must be purchased with the instrument),
• Retroviewer (Option must be purchased with the instrument),
• Sample clamp (HL#D02-1009-200),
• Sensor port-down stand (HL#D02-1009-350),
• Foot switch assembly (HL#D02-1010-327),
• Skein holder (HL#02-7396-00),
• Compression cell set (HL#LSXE-COMP),
• Port inserts (Various part numbers),
• Port insert for capsules (HL#04-7135-00),
• Sample cup set for translucent liquids (HL#LSXE-SC-ASSY),
• Sample cup port plate (HL#A04-1010-316),
• 2.5-inch glass sample cup (HL#04-7209-00),
• Sample cup opaque cover (HL#04-4000-00),
• Ring and disk set (HL#02-4579-00),
• Universal Software (HL#UNI),
• EasyMatch Coatings Software (HL#EZ-C),
• EasyMatch Textiles Software (HL#EZT).
Automated Variable Sample Illumination
The variable sample illumination (VSI) option is installed at the factory and consists of an automatic
zoom lens and three additional magnetic sample port inserts. It provides sample illumination including
the 1.75-inch (44-mm) area, 1-inch (25-mm) area, 0.50-inch (13-mm) area, 0.25-inch (6-mm) area, and
the 0.13-inch (3 mm) area. The illumination spot size should be controlled by your software.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
