01/03 Specifications 6-1
Specifications
The specifications and characteristics of your instrument are given in this section.
Note: Every attempt at accuracy is made, but specifications are subject to change without notice.
For best performance, your instrument should be placed where there is ample work space with medium
or subdued illumination and no drafts. For optimum results, a clean, air-conditioned area is
recommended with a relative noncondensing humidity of 20-80% [10-90% for sensor only] and
relatively constant temperature not exceeding 90°F (32°C) [104°F (40°C) for sensor only]. For
specification performance, the recommended temperature range is 70-82°F (21-28°C).
The instrument should be connected to a stable, instrument-grade power line. If other equipment is
connected to the same power line, a transient power surge may be produced when the other equipment is
turned on. If this happens, restandardize the instrument before making measurements. HunterLab
recommends using a line conditioner with a minimum 600 VA rating and a battery back-up system.
Physical Characteristics
Length 14.5 inches (36.9 cm)
Width 7.5 inches (19.1 cm)
Height 12.0 inches (30.5 cm)
Weight 23 lbs. (10.4 kg)
Computer system Depends upon system purchased. Refer to
manufacturer’s documentation for information.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
